Measure:lower - Agilent Technologies InfiniiVision 5000 Series Programmer's Manual

:MEASure:LOWer

Command Syntax
:MEASure:LOWer <voltage>
The :MEASure:LOWer command sets the lower measurement threshold
value. This value and the UPPer value represent absolute values when the
thresholds are ABSolute and percentage when the thresholds are PERCent
as defined by the :MEASure:DEFine THResholds command.
The :MEASure:LOWer command is obsolete and is provided for backward compatibility to
N O T E
previous oscilloscopes. Use the :MEASure:DEFine THResholds command (see
instead.
Query Syntax
:MEASure:LOWer?
The :MEASure:LOWer? query returns the current lower threshold level.
Return Format
<voltage><NL>
<voltage> ::= the user-defined lower threshold in volts in NR3 format
See Also •
•
•
Agilent InfiniiVision 5000 Series Oscilloscopes Programmer's Guide
(see page 586)
"Introduction to :MEASure Commands"
":MEASure:THResholds"
":MEASure:UPPer" on page 533
Obsolete and Discontinued Commands
on page 257
on page 526
7
page 261)
523