Measure:lower - Agilent Technologies InfiniiVision 3000 X-Series Programmer's Manual

35
Obsolete and Discontinued Commands

:MEASure:LOWer

Command Syntax
:MEASure:LOWer <voltage>
The :MEASure:LOWer command sets the lower measurement threshold
value. This value and the UPPer value represent absolute values when the
thresholds are ABSolute and percentage when the thresholds are PERCent
as defined by the :MEASure:DEFine THResholds command.
The :MEASure:LOWer command is obsolete and is provided for backward compatibility to
N O T E
previous oscilloscopes. Use the :MEASure:DEFine THResholds command (see
instead.
Query Syntax
:MEASure:LOWer?
The :MEASure:LOWer? query returns the current lower threshold level.
Return Format
<voltage><NL>
<voltage> ::= the user-defined lower threshold in volts in NR3 format
See Also •
•
•
1066
(see page 1138)
"Introduction to :MEASure Commands"
":MEASure:THResholds"
":MEASure:UPPer" on page 1076
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
on page 406
on page 1069
page 413)