Trigger:mode - Agilent Technologies InfiniiVision 3000 Programmer's Manual

:TRIGger:MODE

Command Syntax
:TRIGger:MODE <mode>
<mode> ::= {EDGE | GLITch | PATTern | TV | DELay | EBURst | OR | RUNT
The :TRIGger:MODE command selects the trigger mode (trigger type).
Query Syntax
:TRIGger:MODE?
The :TRIGger:MODE? query returns the current trigger mode. If the
:TIMebase:MODE is ROLL or XY, the query returns "NONE".
Return Format
<mode><NL>
<mode> ::= {EDGE | GLIT | PATT | TV | DEL | EBUR | OR | RUNT | SHOL
See Also •
•
•
Example Code
See complete example programs at:
starting on page 1097
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
(see page 1088)
| SHOLd | TRANsition | SBUS{1 | 2} | USB}
| TRAN | SBUS{1 | 2} | USB}
"Introduction to :TRIGger Commands"
":TRIGger:SWEep" on page 853
":TIMebase:MODE" on page 833
' TRIGGER_MODE - Set the trigger mode to EDGE.
myScope.WriteString ":TRIGger:MODE EDGE"
:TRIGger Commands
on page 843
Chapter 39, "Programming Examples,"
30
851