To Display Digital Channels As A Bus - Agilent Technologies 4000 X-Series User Manual

6
Digital Channels

To display digital channels as a bus

Digital channels may be grouped and displayed as a bus, with each bus
value displayed at the bottom of the display in hex or binary. You can
create up to two buses. To configure and display each bus, press the
[Digital] key on the front panel. Then press the Bus softkey.
Next, select a bus. Rotate the Entry knob, then press the Entry knob or
the Bus1/Bus2 softkey to switch it on.
Use the Channel softkey and the Entry knob to select individual channels
to be included in the bus. You can rotate the Entry knob and push it or
push the softkey to select channels. You can also press the Select/Deselect
D15-D8 and Select/Deselect D7-D0 softkeys to include or exclude groups of
eight channels in each bus.
If the bus display is blank, completely white, or if the display includes "...",
you need to expand the horizontal scale to allow space for the data to be
shown, or use the cursors to display the values (see
bus values"
The Base softkey lets you choose to display the bus values in hex or
binary.
The buses are shown at the bottom of the display.
132
If a channel waveform is repositioned over another channel waveform,
the indicator at the left edge of the trace will change from Dnn
designation (where nn is a one or two digit channel number) to D*. The
"*" indicates that multiple channels are overlaid.
on page 133).
Agilent InfiniiVision 4000 X-Series Oscilloscopes User's Guide
"Using cursors to read