Bus<N>:Display - Agilent Technologies InfiniiVision 3000 X-Series Programmer's Manual

:BUS<n>:DISPlay
Command Syntax
:BUS<n>:DISplay <value>
<value> ::= {{1 | ON} | {0 | OFF}}
<n> ::= An integer, 1 or 2, is attached as a suffix to BUS
and defines the bus that is affected by the command.
The :BUS<n>:DISPlay command enables or disables the view of the selected
bus.
This command is only valid for the MSO models.
N O T E
Query Syntax
:BUS<n>:DISPlay?
The :BUS<n>:DISPlay? query returns the display value of the selected bus.
Return Format
<value><NL>
<value> ::= {0 | 1}
See Also •
•
•
•
•
•
Agilent InfiniiVision 3000 X-Series Oscilloscopes Programmer's Guide
(see page 1138)
"Introduction to :BUS<n> Commands"
":BUS<n>:BIT<m>" on page 243
":BUS<n>:BITS" on page 244
":BUS<n>:CLEar" on page 246
":BUS<n>:LABel" on page 248
":BUS<n>:MASK" on page 249
:BUS<n> Commands
on page 242
8
247