Blank - Agilent Technologies InfiniiVision 4000 X-Series Programmer's Manual

6
Root (:) Commands

:BLANk

Command Syntax
:BLANk [<source>]
<source> ::= {CHANnel<n> | FUNCtion<m> | MATH<m> | SBUS{1 | 2}
<source> ::= {CHANnel<n> | DIGital<d> | POD{1 | 2}
<n> ::= 1 to (# analog channels) in NR1 format
<d> ::= 0 to (# digital channels - 1) in NR1 format
<m> ::= 1-4 in NR1 format
<r> ::= 1 to (# ref waveforms) in NR1 format
The :BLANk command turns off (stops displaying) the specified channel,
digital pod, math function, serial decode bus, or reference waveform
location. The :BLANk command with no parameter turns off all sources.
To turn on (start displaying) a channel, etc., use the :VIEW command. The DISPlay
N O T E
commands, :CHANnel<n>:DISPlay, :FUNCtion:DISPlay, :POD<n>:DISPlay,
:DIGital<n>:DISPlay, :SBUS<n>:DISPlay, or :WMEMory<r>:DISPlay, are the preferred
method to turn on/off a channel, etc.
MATH<m> is an alias for FUNCtion<m>.
N O T E
See Also
•
•
•
•
•
•
•
•
•
•
Example Code •
198
(see page 1208)
| WMEMory<r>}
for the DSO models
| BUS{1 | 2} | FUNCtion<m> | MATH<m> | SBUS{1 | 2}
| WMEMory<r>}
for the MSO models
"Introduction to Root (:) Commands"
":DISPlay:CLEar" on page 315
":CHANnel<n>:DISPlay"
":DIGital<d>:DISPlay"
":FUNCtion<m>:DISPlay"
":POD<n>:DISPlay" on page 543
":SBUS<n>:DISPlay" on page 648
":WMEMory<r>:DISPlay"
":STATus" on page 223
":VIEW" on page 226
"Example Code" on page 226
Agilent InfiniiVision 4000 X-Series Oscilloscopes Programmer's Guide
on page 190
on page 268
on page 303
on page 347
on page 1102