Honda CR-V 1997 Service Manual page 887

Power Steering Gearbox
Reassembly (cont'd)
13. Apply power steering fluid to the surface of the spe-
cial tool. Set the new seal rings over the special too l
from the smaller diameter end of the tool, and
expand the seal rings. Install two rings at a time
from each end of the sleeve.
NOt8 these items when installing the seal ring:
• 00 not
over~ expand
the seal ring. Install the resin
seal rings with care so as not to damage them.
After installation, be sure to contract the seal
rings using the special tool (sizing tool),
• There are two types of sleeve seal r ings: black
and brown. Do not mix the different types of
sleeve seal rings as they are not compatible.
14. Align the special tool with each groove in the sleeve,
and slide a sleeve seal ring into each groove. After
installation, compress the seal rings with your fin-
gers temporarily.
BALL JOINT BOOT CLIP GUIDE
0797' - SA!;08100
SLEEVE SEAL RING
---~
Replace. -.. - ..... -
15. Apply power steering fluid to the seal rings on the
sleeve, and to the entire inside surface of the special
tool.
II
SLEEVE SEAL RING
SIZING TOOL
07970 - SAS0200
Or
07974 - SAS020A
16.
Insert the sleeve into the special tool slowly.
17. Move the sleeve each direction several times to
make the seal rings snugly fit in the sleeve. Be sure
that the seal rings are not turned up.
17-42
18. Apply power steering fluid to the surface of the pin-
ion shaft. Assemble the sleeve over the pinion shaft
by aligning the locating p in on the inside of the
sleeve with the cutout in the shaft. Then install the
new circlip securely in the pinion shaft groove.
Note these items during reassembly:
• Be careful not to damage the valve seal ring
when inserting the sleeve.
• Install the circlip with its radiused side facing out.
CIRCLIP
Replace.
PINION SHAFT
•
19. Apply power steering fluid to the seal ring lip of the
valve oil seal, then install the seal in the valve hous-
ing using a hydraulic press and special tools. Install
the valve oil seal wrth its grooved side facing the tool.
DRIVER
07749 - 0010000
ATTACHMeNT,
32x3Smm
077~
- 0010100
VALVE OIL SEAL
Replace.
Make su re the
spring is in the
oil
seal.