Driver's Airbag; Seat Belt Tensioner ('98 - 00 Models) - Honda CR-V 1997 Service Manual

Precautions/Procedures
Disconnecting the Airbag Connectors and the Seat Belt Tensioner
Connectors (cont'd)
1. Disconnect the battery negative cable, then discon-
nect the positive cable from the battery, and wait at
least three minutes.
2. Disconnect the airbag and tensioner connectors
(see page
24-221.
Driver's Airbag:
• Remove the access panel from the steering
wheel, then disconnect the 2P connector
between the driver's airbag and cable reel. When
disconnected, the airbag connector is automati-
cally shorted.
DRIVER'S AIRBAG
2P CONNECTOR
Front Passenger's Airbag:
• Disconnect the 2P connector between the front
passenger's airbag and SRS main harness. When
disconnected, the airbag connector is automati-
cally shorted.
24-24
FRONT PASSENGER'S
AIR BAG 2P CONNECTOR
Seat Belt Tensioner ('98 - 00 modelsl:
• Remove the left and (or) right center pillar lower
trim panels (see section 20).
• Disconnect the seat belt tensioner 2P connectors
from the left side wire harness (driver's side) and
(or) the right side wire harness (front passenger's
side). When disconnected, the seat belt tensioner
is automatically shorted.
CLIPS
SEAT BELT TENSIONER
2P CONNECTOR
DRIVER'S SIDE: LEFT SIDE WIRE HARNESS
FRONT PASSENGER'S SIDE: RIGHT SIDE WIRE
HARNESS