Double Loop - Honda CR-V 1997 Service Manual

Front Driveshafts
Disassembly (cont'd)
Double Loop
DOUBLE LOOP BAND
Replace .
3. Mark each roller and inboard joint to identify the
locations of the rollers and grooves in the inboard
joint. Then remove the inboard joint on the shop
towel. Be careful not to drop the rollers when
sepa~
rating them from the inboard joint.
16-6
INBOARD JOINT
Check splines for wear or damage.
Check inside bore for wear.
Inspect for cracks.
4. Mark the rollers and spider to identify the locations
of the rollers on the spider, then remove the rollers.
BEARING REMOVER
(Commercially available)
5. Remove the circlip.
DRIVESHAFT
6. Mark. the spider and driveshaft to identify the posi-
tion of the spider on the shaft.
7. Remove the spider using a bearing remover.
8. Wrap the splines on the driveshaft with vinyl tape to
prevent damage to the boots and dynamic damper.
INBOARD BOOT
9. Remove the inboard boot and dynamic damper.
Take care not to damage the boot and dynamic
damper.