7.
Glue the fastener to the inside face of quarter glass
as shown. If the old quarter glass is to be reinstalled,
apply a light coat of primer (3M C-100, or equivalent),
then apply butyl tape to the quarter glass as shown.
NOTE:
•
Be careful not to touch the quarter glass where
adhesive will be applied.
•
Do not peel the separator off the butyl tape.
: Butyl tape locations (3M 8628, or equivalent)
Thickness:
3.2
mm
10.13
in.)
Width:
6.4
mm
(0.25
in.)
c>:
Fastener location,
1
BUTYL TAPE
FASTENER
MOLDING
\~
~,
MARK
GLASS
J
III
II
II~
I
\
GLASS
MOLDING
400
mm
115.75
in.)
400
mm
(15.75
in.)
8.
Install the fastener to the body as shown.
C>: Fastener location, 1
9. If the old quarter glass is to be reinstalled, seal the
body hole with piece of urethane tape. Set the quar-
ter glass upright in the opening and make alignment
marks across the quarter glass and body with a
grease pencil atthe three points shown.
10. Remove the quarter glass.
URETHANE
TAPE
ALIGNMENT MARK
(conl'd)
20-37