Power Windows
Master Switch Input Test
NOTE: The control unit is built into the power window master switch and only controls driver's door window operations.
1. Remove the master switch. and disconnect the 14P, 2P and 1 P connectors from the master switch.
2. Inspect the connector and socket terminals to be sure they are all making good contact.
•
If the terminals are bent, loose or corroded, repair them as necessary, and recheck the system,
•
If the terminals look OK, make the following input tests at the connector.
-
If
a test
indicates a problem, find and correct the cause, then recheck the system.
-
If all the input tests prove OK, the power window maser switch must be faulty; replace it.
14P CONNECTOR
1 P CONNECTOR
BLU/ORN
RED/BLU
VEL/BLK
GRN/VEL
Wire side of
female terminals
BLU/BLK
BLK
RED/WHT VEL/GRN
VEL
('99 - 00 models)
POWER WINDOW MASTER SWITCH
23-134
i-----r--
BLK
Wire side of
female terminals
RED/BLK
RED