Honda CR-V 1997 Service Manual page 884

28. Using a cutter or an equivalent tool, cut and remove
the four seal rings from the sleeve. Be careful not to
damage the edges of the sleeve grooves and outer
surface when removing the seal rings.
29.
SLEEVE SEAL RINGS
Replace.
Using a cutter or an equivalent tool, cut the valve
seal ring and a-ring at the groove in the pinion
shaft. Remove the valve seal ring and a-ring. Be
careful not to damage the edges of the pinion shaft
groove and outer surface when removing the valve
seal ring and a-ring.
Cutting slot position.
O·RING
Replace.
VALVE SEAL RING
Replace.
30. Remove the valve oil seal and backup ring ('97
model) or wave washer ('98 - 00 models) from the
pinion shaft.
31.
Note these items during disassembly:
• Inspect the ball bearing by rotating the outer race
slowly. If there is any excessive play, replace the
pinion shaft and sleeve as an assembly .
• The pinion shaft and sleeve are a precise fit; do
not intermix old and new pinion shafts and
sleeves.
BALL BEARING
WAVE WASHER
'~-~~!
'IIIi'7/",
l... . /
I .................. /
PINION SHAFT / -
~/
BACKUP RING
('97 model)
VALVE OIL SEAL
Replace.
Press the valve oil seal and roller bearing out of the
valve housing using a hydraulic press and special
tool shown below.
PILOT COLLAR
07GAF - PH70100
VALVE OIL SEAL
Replace.
ROLLER BEARING
17-39