Honda CR-V 1997 Service Manual page 668

Over-Drive (010) Switch ('99 - 00 Models)
Test
SRS components are located in this area. Review the
SRS component locations, precautions, and procedures
in the SRS section (24) before performing repairs or ser-
vice.
1. Remove the instrument panel lower cover (see sec-
tion 20).
2. Remove the upper and lower steering column cov-
ers (see section 17).
3. Disconnect the park pin switch -
OlD
switch connec-
tor.
4. Check for continuity between the No.1 and No.2
terminals while pressing and holding the
0 10
switch, and when it's released.
There should be continuity while pressing and hold-
ing the switch, and no continuity when it's released.
PARK PIN SWITCH -
0/0 SWITCH
CONNECTOR
Terminal side of
male terminals
5. If the % switch is faulty, replace it and the pari< pin
switch as a set (see page 14-151).
14-152