Honda CR-V 1997 Service Manual page 1063

Rear Hatch Glass
Adjustment (cont'd)
3. After adjusting the rear hatch glass, tighten the rear hatch glass mounting nuts, and install the support strut.
4. Adju st the striker alignment.
NOTE :
• Move the striker fore or aft to make the rear hatch glass fit flush with the tailgate door.
• Move the striker right or left until it's centered in the rear hatch glass latch as shown.
REAR HATCH
GlASS LATCH
o
o
TAILGATE DOOR
5. Tighten the striker mounting bolts.
REAR HATCH GLASS
STRIKER
REAR HATCH
GLASS LATCH
6.' .0
mm
9.8 N·m 11.0 kgf·m.
7.2Ibf.f'1
NOTE: When equalizing the gap between
the tailgate door and rear hatch glass, do not
deform the rear hatch glass.
6. Recheck the rear hatch glass alignment, and make sure the glass opens properly, and locks securely.
7. Install the fear spoiler, and adjust it.
NOTE: Adjust the rear spoiler
so
there are four equal gaps
between t he rear spoiler and
the body.
8. Check for water leaks.
NOTE : Do not squeeze the tip of the hose.
20-82
REAR SPOILER
REAR HATCH GLASS