Honda CR-V 1997 Service Manual page 1133

Air Mix Control Motor
Replacement
1. Disconnect the 5P connector from the air mix con-
trol motor. Remove the self-tapping screws, the air
mix control motor and the flange collar.
5P CONNECTOR
AIR MIX
CONTROL
MOTOR
2. Install in the reverse order of removaL After installa-
Test
1. Disconnect the 5P connector from the air mix con-
trol motor.
2. Connect battery power to the No. 1 terminal of the
air mix control motor, and ground the No.5 termi-
nal; the air mix control motor should run, and stop
at MAX HOT. If it doesn't, reverse the connections;
the air mix control motor should run, and stop at
MAX COOL.
• If the air mix control motor does not run , remove
it, then check the air mi x control linkage and
doors for smooth movement.
• If they move smoothly, replace the air mix con-
trol motor.
AlA MIX CONTROL MOTOR
I~\
3. Measure the resistance between the No.2 and No.3
tion , make sure the air mix control motor runs terminals. It should be approximately 6 kO
±
20%.
smooth Iv.
4. Measure the resistance between the No.2 and No. 4
terminals . It should be approximately 4.8 kG ± 20% at
MAX HOT and approximately 1.2 kO
± 20%
at MAX
COOL.
22-43