Honda CR-V 1997 Service Manual page 550

Description
Hydraulic Flow (cont'd)
2. 2nd Gear
As the speed of the vehicle reaches the prescribed value, shift control solenoid valve A is turned ON by the PCM.
Modulator pressure (6A) in the left end of the '-2 shift valve is released by turning shift control solenoid valve A ON.
The '-2 shift valve is moved to the left side and uncovers the port to allow line pressure (5) to the 2-3 shift valve.
line
pressure 15) changes to 2nd clutch pressure 120) at the 2-3 shift valve. The 2nd clutch pressure 120) is applied to the
2nd clutch, and the 2nd clutch is engaged,
Fluid flows by way of:
-line Pressure (4) - CPB Valve -line Pressure (5) - '-2 Shift Valve - Line Pressure (5) - 2-3 Shift Valve
- 2nd Clutch Pressure 120) - 2nd Clutch
The hydraulic pressure also flows to the 1st clutch. However, no power is transmitted because of the one-way clutch.
NOTE:
• When used, "left" or "rightH indicates direction on the hydraulic circuit .
• The hydraulic circuit shows the '97 - 98 models (7 positions); the '99 - 00 models (6 positions) is similar.
14-34