Honda CR-V 1997 Service Manual page 828

4. Insert the driveshaft into the outboard joint until the
stop ring is close on the joint.
DRIVESHAFT
OUTBOARD JOINT
5. To completely seat the outboard joint, pick up the
driveshaft and joint, and drop them from about 10
cm (4 to 5 inches) onto a hard surface. 00 not use a
hammer as excessive force may damage the drive-
shaft.
6. Check the alignment of the paint mark with the out-
board joint end.
DRIVESHAFT
7. Pack the outboard joint with the joint grease included
in the new joint boot set.
Grease quantity:
Ou1board joint: '97 model and '98 USA model
130 - 140 9 (4.6 - 4.9 oz)
'98
Canada model
and oil '99 - 00 models
140 - 150 9 (4.9 - 5.3 oz)
DRIVESHAFT
(conl'd)
16-13