Honda CR-V 1997 Service Manual page 826

10. Set the double loop band onto the boot or dynamic
damper with the band end toward the front of the
vehicle.
DOUBLE LOOP BAND
Front
11. Pull up the slack in the band by hand.
12. Make a mark on the band 10 - 14 mm 10.4 - 0.6 in)
from the Clip.
CLIP
13. Thread the free end of the band through the nose
section of a commercially available boot band tool
IKD-3191 or equivalent), and into the slot on the
winding mandrel.
14. Place a wrench on the winding mandrel of the boot
band tool, and tighten the band until the marked
spot on the band meets the edge of the clip.
BOOT BAND TOOL
(KD·3191
or equivalent)
Mark on band.
15. Lift up the boot band tool to bend the free end of
the band 90 degrees to the Clip. Center-punch the
clip, then fold over the remaining tail onto the Clip.
lcont'd)
16-11