Honda CR-V 1997 Service Manual page 1386

Driver's Airbag
Replacement (cont'd)
CAUTION: Be sure to install the SRS wiring
10
that
it
il
not pinched or interfering with other parts.
4. Place the new driver' s airbag into the steering
wheel, and secure it with new Torx bolts.
24-88
TORX BOLTS
9.8 N·m 11.0 kgf·m,
7.21bf.ftl
Replace .
Use.
DRIVER'S AIfIBA,G
5. Connect the driver's airbag 2P connector to the
cable reel 2P connector, then install the access
panel on the steering wheel.
DRIVER'S AIR BAG
2P CONNECTOR
CABLE REEL
2P CONNECTOR
6. Connect the battery positive cable, then connect the
negative cable.
7.
After installing the airbag assembly, confirm proper
system operation:
• Turn the ignition switch ON (II); the SRS indica-
tor light should come on for about si x seconds
and then go off.
• Make sure both horn buttons work.
• Take a test·drive, and make sure the cruise con-
trol switches work.