Tailgate Door Panel Removal And Installation - Honda CR-V 1997 Service Manual

6. Grease all the sliding surfaces of the regulator where
shown.
NOTE: If it is necessary to remove the power win-
dow motor from the regulator, scribe a line across
the sector gear and regulator before you remove the
power window motor.
SECTOR GEAR
... : Boft locations. 3
@mID
6xl .0mm
7 N·m (0.7 kgf·m ,
5 Ibf.ftl
REGULATOR
POWER
WINDOW
MOTOR
POWER WINDOW MOTOR
7. Installation is the reverse of the removal procedure,
NOTE: Roll the glass up and down to see if it moves
freely without binding. Also make sure that there is
no clearance between the glass and glass run chan-
nel when the glass is closed. Adjust the position of
the glass as necessary (see page 20-20).
Tailgate Door Panel Removal and
Installation
NOTE: Take care not to scratch the door panel and
other parts.
1, Remove the cover , and remove the flexible cargo
hook and base.
..: Screw locations, 2
COVER
I~
' , '
r
FLEXIBLE CARGO
HOOK BASE
HOOK
i-~
, FLEXIBLE
, CARGO HOOK
2. Remove the tailgate door lid, then remove the screws.
.. : Screw locations, 2
TAILGATE
DOOR LID
t> :
Clip locations, 10
DOOR PANEL
3. Release the clips that hold the tailgate door panel.
then remove the tailgate door panel.
4. Installation is the reverse of the removal procedure.
NOTE: If necessary, replace any damaged clips.
20-15