Rear Accessory Socket - Honda CR-V 1997 Service Manual

Rear Accessory Socket:
1. Remove the left rear side trim panel (see section
201.
2. Disconnect the connectors.
3. 1nspect the connector terminals to be sure they are
all making good contact.
• If the terminals are bent, loose or corroded.
repair them as necessary, and recheck the sys -
tem.
• If the terminals look OK, go to step 4.
ACCESSORY
SOCKET
BIBLK)
4. Turn the ignition switch to ACC
(I),
and check for volt-
age between the A and B termina ls.
• There should be battery voltage.
• If there is no battery voltage. check for:
- blown No.6 110 AI and No. 27 110 AI fuses in
the under-dash fuse/relay box.
- faulty rear accessory socket relay (test, page
23-531.
- poor ground IG401, G402, G5531.
- an open in the wire.
5. Remove the thermofuse housing and thermal pro-
tector, then remove the socket and cover.
THERMAL
PROTECTOR
THERMO FUSE
HOUSING
COVER
SOCKET
23-97