Honda CR-V 1997 Service Manual page 687

13. Pry the right driveshaft out of the differential, and
pry
the left
driveshaft out of the intermediate shaft
(see section 16).
14. Pull out the inboard joint, and remove the right and
left driveshaft (see section 18).
15. Tie plastic bags over the driveshaft ends. Coat all
precision finished surfaces with clean engine oil.
DRIVESHAFT
SET RING
Rep lace.
16. Disconnect the primary heated oxygen sensor
(Primary H02S) connector.
17. Remove exhaust pipe A.
GASKET
Replace .
I
SELF·LOCKING
NUT
Re place.
Replace.
PRIMARV
H02S CONNECTOR
@)
SELF-LOCKING NUT
\ Repla ce .
GASKET
Re place.
18, Remove the shift cable cover.
19. Remove the shift cable.
4WD:
Remove the snap pin and co ntrol pin, then separate
the shift cable from the control lever. Do not bend
the shift cable excessively.
LEVER
2WD:
CONTROLPfN
SHIFT CABLE
COVER
CABlE
Remove the control lever, then separate the shift
cable from the control shaft. Do not bend the shift
cable excessively.
SHIFT CABLE
LOCKWASHER CONTROL LEVER
Replace .
(conl'd)
14-171