Honda CR-V 1997 Service Manual page 1394

SRS Unit
Replacement (cont'd)
6. Install the new SRS unit. If the Torx bolts you
removed in the previous step have red threads,
replace the Torx bolts.
SRS MAIN HARNESS
t8P CONNECTOR
TORXBOLTS
SRS UNIT
TORX BOLTS
9.8 N'm (1.0 kgf·m, 7.2 Ibf.ftl
Use a Tonc
no
bit.
9.8 N·m (1.0 kgf·m, 7.2 Ibf.ftl
Use a TOD: T30 bit.
7. Connect the SRS main harness l8P connector to the
SRS unit; push it into position until it clicks .
8. Install the SRS unit covers (right and leftl. Make
sure the covers snap together in the middle.
24-96
9. Reconnect the driver's airbag 2P connector to the
cable reel 2P connector, then reinstall the access
panel on the steering wheel.
10. Reconnect the front passenger's airbag connector
to the SRS main harness.
11. Reconnect the left side wire harness 2P connector
to the driver's seat belt tensioner and the right side
wire harness 2P connector to the front passenger's
seat belt tensioner ('98 - 00 modeisi.
12. Reinstall the center pillar lower trim panels ('98 - 99
modeisi.
13. Reconnect the battery positive cable, then the nega-
tive cable.
14. After installing the SRS unit, confirm proper system
operation: Turn the ignition switch ON (III; the SRS
indicator light should come on for about si)( seconds
and then go off.