Sub-Shaft Bearings - Honda CR-V 1997 Service Manual

Sub-shaft Bearings
Replacement
NOTE: Lubricate all parts with ATF before reassembly.
1. Expand the snap ring with snap ring pliers, then
push the bearing out of the transmission housing
using the special tools and a press as shown.
PRESS
ATTACHMENT,
62x68mm
07746 - 0010500
2. Remove the needle bearing stop.
3. Remove the needle bearing from the transmission
housing using a drift.
14-212
4. Install a new needle bearing in the housing using
the special tools and a press as shown.
5. Expand the snap ring with snap ring pliers, then
insert the ball bearing part-way into the housing
using the special tools and a press as described in
step 1. Install the bearing with the groove facing
outside the housing .
6. Release the pliers, then push the bearing down into
the housing until the snap ring snaps in place
around it.
7. After installing the ball bearing verify the following:
• The snap ring is seated in the bearing and hous-
ing grooves .
• The ring end gap is correct.
END GAP: 0-7 mm
10 - 0.28
Inl
SNAP RING