Honda CR-V 1997 Service Manual page 703

1. Remove the Af T gear position switch ha r ness
clamp.
2. Remove the
AfT
gear position switch cover.
3. Remove the bolt securing the NT gear position switch
hamess clamp on the end cover, then remove the NT
gear position switch.
4. Remove the 12 bolts securing the end cover, then
remove the cover.
5.
Slip the special tool onto the mainshaft as shown.
MAINS HAFT HOLDER
07GAB - PF50101
or
07GAB - PF50100
6. Engage the park pawl with the park gear.
7. Cut the lock tabs of each shaft locknut using a chisel as
shown.
Keep aU chiseled particles out of the transmis·
sian.
' - - _ - CHISEL
LOCKNUT
~~~~--LOCK
TAB
8. Align the hole of the sub-shaft 1st gear with the hole
of the transmission housing, then insert a pin to lock
the sub·shaft while removing the sub·shaft locknut.
Remove the locknuts and conical spring washers from
each shaft.
NOTE:
• Mainshaft and countershaft locknuts have left·
hand threads.
• Clean the old countershaft locknut. It is used to
install th e press fit park gear on the countershaft.
SUB-SHAFT
MAINSHAFT
LOCKNUT
PIN LOCKNUT
8 mm pin ,
commercially
I
Rep lace.
CONICAL SPRING WASHERS
Replace.
COUNTERSHAFT
LOCKNUT
Replace .
9. Remove the lock pin that was installed to hold the
sub-shaft.
10. Remove the special tool from the mainshaft.
11. Remove the 1st clutch, mainshaft 1st gear assembly,
and mainshaft 1st gear collar.
12. Remove the sub-shaft 1 st gear.
13. Remove the park pawl, pawl spring, pawl shaft, and
pawl stop.
14. Remove the park lever from the control shaft.
15. Using a universal two jaw puller, remove the park
gear, one·way clutch, and countershaft 1st gear
assembly.
PUUER
(Commercia ll y available)
I
COLLAR
. 6 _· " 'j~ ' . ~ _.
_ _
" " , O
;.N _ ~
COUNTERSHAFT
1ST GEAR
PARK GEAR
16. Remove the needle bearing and countershaft 1st gear
collar.
17. Remove the ATF cooler lines.
14-187