Clutch Inspection - Honda CR-V 1997 Service Manual

Clutch Inspection
• Check the plated parts of the armature plate for color
changes, peeling or other damage. If there is dam-
age, replace the clutch set.
• Check the rotor pulley bearing play and drag by rotat-
ing the rotor pulley by hand. Replace the clutch set
with
a new one
if it
is noisy or
has excessive play/drag.
ROTOR
PULlEY
• Measure the clearance between the rotor pulley and
the armature plate all the way around . If the clear·
ance is not within specified limits. the armature plate
must be removed and shims added or removed as
required, following the procedure on page 22-66.
Clearance: 0.5 ± 0.15 mm (0.020
±
0.006 inl
NOTE: The shims are available in four thicknesses:
O. I mm, 0.2 mm, 0.4 mm and 0.5 mm
ARMATURE
ROTOR
PULLEY
• Release the field coil connector from the holder, then
disconnect it. Check the thermal protector for conti-
nuity. If there is no continuity, replace the thermal
protector.
NOTE: The thermal protector will have no continuity
above 251.6 to 262.4°F (122 to 128°C). When the tem-
perature drops below 240.8 to 219.8' F (116 to 104°CI,
the thermal protector will have continuity.
• Check resistance of the field coil.
Field Coil Resistance: 3.2
±
0.15 ohm. at 68"F (20°C)
If resistance is not within specifications, replace the
field coil.
22-65