Honda CR-V 1997 Service Manual page 445

Transfer Assembly
Installation
1, Install a new O-ring on the transfer assembly.
8 x 1.25 mm 10
x
1.25
mm
REAR STIFFENER
24 N'm 12.4 kgf·m.
171bUt,
44 N·m
14.5
kgf·m .
33
Ibf.ft'
2.
3.
!
_1"1
j"
i
\,,-.,
/
u 'l1
.-/ ' ./0 '
!
~:s ~\ !
~I
DD~L~N--
__
-;~ I ~~~~
O·RING
Replace .
TRANSFER
ASSEMBLY
Clean the areas where the transfer assembly con-
tacts the transmission with solvent or carburetor
cleaner, and dry with compressed air. Then apply
MTF to the contact areas.
Install the transfer assembly on the transmission ,
NOTE : While installing the transfer assembly on
the transmission, do not allow dust or other foreign
particles to enter the transm ission.
4. Install the rear stiffener.
5. Install the propelier shaft to the transfer assembly
by aligning the reference marks.
13-6
8 x1 .25 mm
32 N·m 13.3 kgf·m.
241bUt,
Replace.
REFERENCE MARKS
6. Instali the exhaust pipe A.
GASKET
10 x 1.25 mm
54 N·m 15.5 kgf·m.
40lbUti
Replace.
SELF-LOCKING NUT
8x1.25mm
22 N'm 12.2 kg/·m.
161bUti
Replace.
EXHAUST PIPE A
Replace.
8x1.25mm
16 N'm (1.6 kgf·m,
121b"'t,
Replace.
7. Connect the heated oxygen sensor IH02S) connector.
8. Refill the transmission with MTF (see page 13-3).
9. Start the engine, and run it to normal operating tem-
perature (the radiator fan comes on). Turn the
engine off, and check fluid level.