Honda CR-V 1997 Service Manual page 770

Transmission
Reassembly (cont'd)
27. Install the mainshaft speed sensor (with new
0 -
ring) on the transmission housing.
28. Install the park lever on the control shaft, then
install the lock bolt with a new lock washer. 00 not
bend the lock tab of the lock washer in this step;
bend
it
after checking the park pawl engagement in
step 45.
29. Assemble the one-way clutch and the park gear on
the countershaft 1st gear (see page 14-209).
30. Lubricate these parts with ATF:
• Countershaft threads
• Old locknut threads and nat end
• Old conical spring washer
• Park gear contact area with conical spring
washer
31. Install the countershaft 1st gear collar, needle bear-
ing, and the countershaft 1st gear/ park gear assem -
bly on the countershaft.
32. Install the park pawl shaft, pawl spring, pawl, and
pawl stop on the transmission housing, then
engage the pawl with the park gear.
PARK GEAR
ONE-WAY
CLlJTC:H
1 ST GEAR COLLAR
14-254
PAWL STOP
I
LOCK BOLT
PARK
LEVER
PAWL SHAFT
COUNTERSHAFT
33. Install the old locknut and the old conical spring
washer on the countershaft. Tighten the old locknut
to seat the park gear to the specified torque, then
remove the washer and locknut. The locknut has
left-hand threads. 00 not use an impact wrench.
Always use a torque wrench to tighten the locknut.
TORQUE: 103 N'm (10.5 kg/·m, 75.9Ibf.ft)
LOCKNUT
Use old one.
CONICAL SPRING
WASHER
34. Slip the special tool onto the mainshaft.
MAINSHAFT HOWER
07GAB - PF50101
or
07GAB - PF50100