Honda CR-V 1997 Service Manual page 878

20. Remove the rear mount bracket and rear mount.
REAR MOUNT
12 x 1.25 mm
REAR MOUNT BRACKET
14x 1.5 mm
Replace.
21. Place a jack under the engine block in the area
shown .
JACK·UP POINT
22. Jack. up the engine and tilt the engine back until the
transfer assembly is lowered approximately 40 mm
(1.57
in).
Note these items when tilting the engine:
• Check that the wire harnesses, hoses and pipes
are not caught by any surrounding parts.
• Do not tilt the engine more than necessary.
TIUINSFERASSEMBLY
23. Remove the stiffener plate.
NOTE: Some stiffener plate mounting bolts are also
used as gearbox mounting bolts. The gearbox will
tilt to the side when these bolts are removed.
STIFFENER PlATE
(conl'd)
17-33