Honda CR-V 1997 Service Manual page 657

8. Set the control shaft to
[ill
position, then install the
Aff
gear position switch on it.
CONTROL SHAFT
9. Install the AfT gear position switch cover and har·
ness clamp on the end cover .
10. Connect the
Aff
gear position switch connector,
then install it on the connector bracket.
11. Turn the ignition switch ON
(II) .
Move the shift lever
through all gears, and check the
AfT
gear position
switch synchronization with the
AfT
gear position
indicator.
GAUGE ASSEMBLY
AIT
GEAR POSITlON
INDICATOR
'99 - 00 MODELS
AIT GEAR POSITION
INDICATOR
'97 - 98 MODELS
12. Start the engine. Move the shift lever through all
gears, and verify the following :
• The shift lever cannot be moved to
00
position
from
[!J
position unless the shift lever is pulled.
• The engine wilt not start in any position other
than
[ill
or
~.
• The back-up lights come on when the shift lever
is in
[BJ
position.
14-141