Honda CR-V 1997 Service Manual page 492

Transfer Gear Backlash Inspection and Transfer Gear
Tooth Contact Inspection
2. Install the 35 mm thrust shim on the transfer driven
gear shaft, then install the tapered roller bearing
using the special tools and a press.
NOTE: Use old transfer spacer for bearing installa-
tion, then discard it.
PRESS
IL
DRIVER 40 mm I.D.
t
07746 - 0030100
TAPERED ROLLER ' /
BEARING / O L D TRANSFER
/
TRANSFER DRIVEN
GEAR SHAFT
SPACER
3. Install the bearing outer
race,
then the tapered bear-
ing on the
companion flange side of the tran sfer
housing.
OIL SEAL DRIVER
ATTACHMENT
07JAO - PH80101
Replace ,
TAPERED ROLLER
BEARING
4. Insta ll the new oil seal o n the transfer housing
using the special tools.
5. Install the transfer driven gear shaft in the transfer
housing . Do not install the transfer spacer on the
transfer driven gear shaft in this step.
TRANSFER
HOUSING
6. Install the companion flange. conical spring washer,
and locknut on the transfer driven gear shaft. Do
not install the O-ring and the back-up ring on the
transfer gear shaft in this step.
FLANGE
TRANSFER DRIVEN
GEAR
CONICAL SPRING
WASHER
Install in direction.
(conl'd)
13-53