Honda CR-V 1997 Service Manual page 811

3. Install the special tools on the companion flange.
HOlD£R HANDLE
07JAB - 001020A
I
B.1.25mm
32 N·m 13.3 kgf·m. 2411,,,,,,
4. Loosen the locknut counterclockwise so that its tab
comes out from the groove in the clutch guide.
LOCKNUT. 24
mm
Tab
5. Tighten the locknut till its tab aligns with the groove.
6. Remove any dirt from inside of the groove in the
clutch guide, then loosen the locknut.
LOCKNUT. 24 mm
Tab
7. Remove the locknut, the disc spring washer, the
back-up ring, the O-ring and the companion flange.
~
LOCKNUT. 24
mm
Replace.
~
/ DISC SPRING WASHER. 24
mm
~ BACK-UP
RING
O-RING
0...---
Replace.
~
COMPANION FLANGE
B. Remove the torque co ntrol differential case and the
dowel pins.
TORQUE CONTROL DIFFERENTIAL
CASE
6x 10mm
DOWEL PINS
(conl'dl
15-21