Honda CR-V 1997 Service Manual page 1353

From page
24-54
I
Check for a short power in the cable reel (cont'd):
5. Reconnect the battery positive cable. then reconnect the
negative cable .
6. Erase the DTe memory (see page 24-2S).
7.
Read the
OTe
(see page
24-26).
Is DTC 1·4 indicated?
YES
NO
r
Short to power in the cabte reel; replace the cable reet
I
I . . . . . ge 24·911.
Check for a short to power in the SRS main harness:
1. Disconnect the battery negative cable, then disconnect
the positive cable. and wait for three minutes.
2. Disconnect the front passenger's airbag connector (and
disconnect both seat belt tensioner con nectors).
3. Remove the special tool (2 m from the SRS main harness
2P
connector.
4.
Disconnect the SRS main harness
lSP
connector from
the SRS unit.
S. Reconnect the battery positive cable. then reconnect the
negative cable.
6. Connect a voltmeter between the No. 1 .... ) terminal of
the SRS main harness lSP connector and body ground.
7. Turn th e ignition switch ON
(II),
and meas ure voltage.
There should be
0.5 V
or less.
B. Turn the ignition switch OFF.
9. Connect a voltmeter between the No. 13
(+)
terminal of
the SRS main harness lBP connectOr and body ground.
10. Turn the ignition switch ON
(II).
and measure voltage.
There should be O.S V or less.
Are voltages as specified?
YES NO
Faulty SRS unit; replace the SRS unit lsee page 24-95).
l
Short to power In
the
SRS main harness; replace the SRS
l
main harness.
SRS MAIN HARNESS
laP CONNECTOR
SRS UNIT
10 11 12 13 H 15 16 17 18
W ire side ollemale
terminals
24-55