Honda CR-V 1997 Service Manual page 553

00
Position
Fluid flow through the torque converter circuit is the same as in
00
position. Line pressure (1) changes to line pressure (3)
and flows to the ' ·2 shift valve. Line pressure (3) changes to line pressure
(3')
at the 1-2 shift valve and flows to the servo
valve . The servo valve is moved to the right side (Reverse range position) and uncovers the port to allow line pressure (3")
to the manual valve. line pressure (3') from the
' ·2
shift valve flows through the servo valve to the manual valve and
changes to 4th clutch pressure 140). The 4th clutch pressure 140) is applied to the 4th clutch, and the 4th clutch is engaged.
Reverse Inhibitor Control
When the
(ft]
position is selected while the vehicle is moving forward at speeds over 6 mph (10 km/h), the PCM outputs the
1st speed signal to shift control solenoid valves A and B; shift control solenoid valve A is turned OFF, shift control solenoid
valve B is turned ON. The '-2 shift valve is moved to the right side and covers the port to stop line pressure
(3')
to the
servo valve. Line pressure
(3' )
is not applied to the servo valve, and 4th clutch pressure (40) is not applied to the 4th
clutch, as a result, power is not transmitted to the reverse direction.
NOTE:
• When used, "'eft'" or " right " indicates direction on the hydraulic circuit .
• The hydraulic circuit shows the '97 - 98 models 17 positions); the '99 - 00 models 16 positions) is similar.
Icont'd)
14-37