Honda CR-V 1997 Service Manual page 451

Transmission Assembly
Illustrated Index
Refer to the drawing below for the transmission disassembly/reassembly .
Clean all the parts thoroughly in solvent, and dry with compressed air.
- , lubricate all the parts with MTF before reassembly.
NOTE:
• This transmission uses no gaskets between th e major housings; use liquid gasket (PIN 08718 - 0001 or 08718 - 0003)
(see page 13-69. 711.
• Always clean the magnet
@
whenever the transmi ssion housing is disassembled.
• Inspect all the bearings for wear and operation.
(j)
SHIFT FORK ASSEMBLY
• Index page, 13·21
®
MAINSHAFT ASSEMBLY
• Ind ex page, 13·23
®
28 mm WASHER
@
28 mm SPRING WASHER
®
BAll BEARING
@ Oil SEAL Replace.
ZV
14 x 20 mm DOWEL PIN
®
COUNTERSHAFT ASSEMBLY
- Index page, 13·28
13-12
®
NEEDLE SET PLATE
@
NEEDLE BEARING
@
Oil GUIDE C PLATE
®
MAGNET
®
DIFFERENTIAL ASSEMBLY
• Index page, 13-38
@
a ·RING Replace.
@ TRANSFER ASSEMBLY
• Index page, 13-44
@ Oil SEAL Replace.
®
VEHICLE SPEED SENSOR
@
CLUTCH HOUSING
@
REVERSE lOCK CAM
@
REVERSE SHIFT HOLDER
@
REVERSE IDLE GEAR
@
REVERSE GEAR SHAFT
@
THRUST WASHER. 20 x 36 x 2
@
COLLER. 15 x 20 )( 20