Honda CR-V 1997 Service Manual page 1029

Dashboard
Driver's Dashboard Lower Cover and Knee Bolster Removal and Installation
SRS
compo nents are
located in this area. Review the SRS
component locations, precautions, and procedures in the
SRS section (24) before performing repairs or service.
CAUTION:
• When prying with a flat-tip screwdriver, wrap
it
with
protective tape, and apply protective tape around the
related parts, to prevent damage.
• Put on gloves to protect your hands.
NOTE: Take care not to scratch the dashboard and related
parts.
1, Remove the screws, and detach the clips, then
remove the driver's dashboard lower cover. Discon-
nect the rear hatch glass opener switch connector .
.. : Screw locations. 2
t>: Clip
locations
A <>, 3 8 <>, 1
20-48
2. Remove the bolts, then re move the knee bolster.
.. : Boft Ioc::ations. 3
@)rnm
6
x
1.0
mm
9.8 N·m 11 .0 kg/·m,
7.2lbf.ftl
KNEE BOLSTER
3. Installation is the reverse of the removal procedure.
NOTE: Make sure the connector is connected prop-
p.rlv .