Transmitter Programming - Honda CR-V 1997 Service Manual

Transmitter Programming
Storing transmitter codes:
The codes of up to three transmitters can be read into
the keyless receiver unit memory.
(If
a fourth code is
stored, the code which was input first will be erased.)
NOTE: It is important to maintain the time limits
between the steps.
1. Turn the ignition switch ON (II).
2. Within 1 to 4 sec., push the transmitter lock or unlock
button with the transmitter aimed at the vehicle.
3. Within 1 to 4 sec., turn the ignition switch OFF.
4. Within 1 to 4 sec., turn the ignition switch ON
(II).
5. Within 1 to 4 sec., push the transmitter lock or
unlock button with the transmitter aimed at the
vehicle.
6. Within 1 to 4 sec., turn the ignition switch OFF.
7. Within 4 sec., turn the ignition switch ON (II).
8. Within' to 4 sec., push the transmitter lock or
unlock button with the transmitter aimed at the
vehicle.
9. Within 1 to 4 sec., turn the ignition switch OFF.
10. Within 4 sec., turn the ignition switch ON (II).
11. Within 1 to 4 sec., push the trensmitter lock or
unlock button with the transmitter aimed at the
vehicle.
12. Confirm you can hear the sound of the door lock
actuators.
13. Within 8 sec., aim the transmitters (up to three)
whose codes you want to store at the receiver, and
press the transmitter lock or unlock buttons.
Confirm that you can hear the sound of the door
lock actuators after each transmitter code is stored.
14. Turn the ignition switch OFF, and pull out the key.
15. Confirm proper operation with the new code(s).
23-131