Rear Driveshafts
Reassembly (cont'd)
8.
Install the joint by holding the drives haft straight up
and aligning the marks on the joint with the marks
on the rollers.
Marks
9.
Adjust the position of the joints to the specifications
shown. then adjust the boots halfway between full
compression
and full
extension.
Make sure the ends
of the
boots
are seated
in
the grooves in the
joints.
Inboard joint length:
153 - 157 mm (6.02 - 6.1S
in)
Outboard joint (ength:
143 - 147
mm (5.63 - 5.37
in)
16-28
10.
Set the double loop band
onto
the boot with the
band end toward the front of the vehicle.
DOIUBILE lOOP BAND
Front
11.
Pull up the slack in the band
by
hand.
12. Make a mark
on
the band 10 - 14 mm (0.4 - 0.6 in)
from the clip.
CLIP