Honda CR-V 1997 Service Manual page 781

17, Make sure the transmission is in
~
position,
Fill the transmission with ATF, and run the engine
for 30 seconds or until approximately 0.95 f (1.0 US
qt .. 0.8 Imp qt.) is discharged.
18, Remove the drain hose, and reconnect the cooler
return hose to the transmission (see page 14·266).
19. Refill the transmission with ATF to th e proper level
(see page 14· 161).
TOOL MAINTENANCE
1. Empty and rinse the flusher after each use, Fill the
flusher with water and pressurize it, then flush the
discharge line to ensure that the unit is clean.
2. If discharge liquid does not foam, the orifice may be
blocked.
3. To clean, disconnect the large co upling nut from the
flusher.
ALLER CAP
FILTER COUPLING
NUT
ORIFICE
O·RING
4. Remove the in·line filter from th e discharge side and
clean
it if
necessary.
5. The fluid orifice is located behind the filter.
Clean it with the pick stored in the bottom of the
tank handle, or blow it clean with air.
6. Reassemble all parts,
14-265