Honda CR-V 1997 Service Manual page 726

Sub-shaft
Disassembly /Inspection/Reassembly
NOTE:
• Lubricate all parts with ATF before reassemb ly.
• Inspect the thrust needle bearings and the needle bearings for galling and rough movement.
• Before installing the O-rings, wrap the shaft splines with tape to prevent damaging the O-rings.
SNAP ",.,"-___
6.1.0 m m _ - - - t -..... !t:lJ
12 N'm
11 .2 kgf·m. 8.7Ibf.f.,
SUB. SHAFT
-;:;;;~~ve--::::::::::i:;J~
Check splines for
w ear and damage .
Check bearing surface for scoring,
scratches and excessive wear.
ATF GUIOE CAP
Replace .
14-210
TRANSMISSION HOUSING
NEEOLE BEARING
STOP
TRANSMISSION HOUSING
BEAR1NG
1 ST ·HOLD CLUTCH
ASSEMBLY
O·RINGS
Replace .
WASHER
THRUST NEEDLE
BEARING
NEEDLE BEAR1NG
4TH GEAR
THRUST NEEDLE BEARING
4TH GEAR COLLAR
NEEDLE BEARING