Shift Lever - Honda CR-V 1997 Service Manual

Shift Lever
Removal/Installation
SRS
components are
located in this area. Review the
SRS component locations, precautions, and procedures
in the SRS section (24) before performing repairs or ser-
vice.
1. Remove the instrument panel lower cover and the
column covers (see section 17).
2. Shift to
[R]
position, then remove the lock pin from
the cable adjuster.
3. Separate the shift cable from the cable adjuster. Do
not bend the shift cable excessively.
ADJUSTER ROD
4. Remove the flange nuts and bolts securing the
steering column, then lower the steering column.
8x 1.25 mm
22N·m 12.2
SHIFT
SOLENOID
CONNECTOR
.161bf.ftJ
SHIFT LEVER
ASSEMBLY
STEERING
FU.N'" NUTS
16 N·m 11.6 kgf·m. 12 Ibf.ftJ
5. Disconnect the shift lock solenoid and the park pin
switch connector.
6. Remove the bolts securing the shift lever assembly,
then remove the shift lever assembly.
7. Install the shift lever assembly in the reverse order
of removal.
NOTE:
• Make sure the lock pin is seated securely in the
cable adjuster.
• Replace the lock pin if it does not snap over the
cable adjuster securely.
8. Check the cable adjustment after installing the shift
lever (see page 14-271).
14-267