Ignition Switch; Electrical Switch Replacement - Honda CR-V 1997 Service Manual

Ignition Switch
Test
SAS components are located in this area . Review the
SRS component locations. precautions, and procedures
in the SRS section (24) before performing repairs or ser-
vice.
1. Make sure you have the anti-theft code for the
radio . then write down the frequencies for the
radio's preset buttons (with anti-theft feature).
2. Disconnect the battery negative cable .
3. Rem o ve the driver's dashboard lower cover and the
knee bolster (see section 20).
4. Disconnect the 5P connector from the under-dash
fuse/relay box and the 3P connector from the main
wire harness.
3P CONNECTOR
Wire side of
female terminals
female terminals
5. Check for continuity between the terminals in each
switch position according to the table.
1\
Terminal
1
[3] 5
3
[1 [
Position
\
IACC) IBAT) IIG1J IIG2) 1ST)
o
ILOCK)
IIACC)
iliON)
V--
-0
--<J-
r-u
III 1ST ART)
0 -0
u
f
J:
3P connector
6. If the continuity checks do not agree with the table,
replace the electrical switch.
7. After reconnecting the battery, enter the anti-theft
code for the radio, then enter the customer' s radio
station presets (with anti-theft feature) .
23-54
Electrical Switch Replacement
SRS components are located in this area. Review the
SRS component locations, precautions, and procedures
in the SRS section (24) before performing repairs or ser-
vice .
1. Make sure you have the anti-theft code for the
radio, then write down the frequencies for the
radio's preset buttons (with anti-theft feature).
2. Disconnect the battery negative cable.
3. Remove the driver's dashboard lower cover and the
knee bolster (see section 20).
4. Disconnect the 5P connector from the under-dash
fuse/relay box and the 3P connector from the main
wire harness (see left column).
5. Remove the steering column covers (see section
17).
6. Insert the ignition key, and turn it to "0".
7. Remove the two screws and the electrical switch
from the steering lock.
SWITCH
LOCK CYLINDER
8. Install in the reverse order of removal.
9. After reconnecting the battery, enter the anti -theft
code for the radio, then enter the customer's radio
station presets (with anti-theft feature).