Front Driveshafts
Reassembly (cont'd)
7.
Fit the inboard joint onto the driveshaft, and note
these items:
•
Reinstall the inboard joint onto the driveshaft by
aligning the marks on the inboard joint with the
marks on the rollers.
•
Hold the driveshaft so the inboard joint points up
to prevent it from falling off.
INBOARD
JOINT
~
t
Spline direction
~~\.
~::0
<:L~HOLDER
8.
Adjust the length of the driveshafts to the specifica-
tions shown, then adjust the boots to halfway
between full compression and full extension. Make
sure the ends of the boots seat in the grooves of the
driveshaft and joint.
16-10
Left: 508 - 513 mm (20 - 20.2 in)
I
I
d(]]tV~
Righ1:
AT
model 520 - 525 mm (20.5 - 20.7 in)
MT model 515 - 520 mm (20.3 - 20.5 in)
9.
Position the dynamic damper to the specifications
as shown.
Left: 299.5 ± 2 mm 111.8 ± 0.1 in)
Right: 299.5
±
2 mm 111.8
±
0.1 in)
' "
DYNAMIC
DAMPER
' I
OUTBOARD JOINT