Honda CR-V 1997 Service Manual page 1373

From page 24 -74
I
Chedc for ... open in the side wire harness:
1. Disconnect the right side wire harness 2P connector from
the SRS main harness 2P connector.
2. Connect th e special tool (2
m
to the SRS main harness
2P connecto r.
3. Erase the DTC memory.
4. Read the OTC.
Is DTC 4·' or DTe 4·2 indicated?
YES NO
!
Open or increased resistance in the right side wire har-
ness; replace the harness.
Check for an open in the SRS main harness:
1. Disconnect the negative battery cable, and wait for three
minutes.
2. Disconnect the driver's and front passenger's airbags,
and driver's seat belt tensioner connectors (see page 24-
23).
3. Disconnect th e SRS main harness
lap
connector from
the SRS un it. Do not disconnect the special toot (2 {])
from the SRS main harness 2P connector.
4. Check resistance between the No. S and No. 12 terminals
of the SRS main harness lap connector. There should be
2.0 - 3 .0 Il .
Is the resistance as specified?
YES NO
Faulty SRS unit or poor contact at the SRS main harness
18P connector and the SRS unh:. check the connection
between the SRS main harness 18P connec1or and the
SRS unit. If the connector is OK. replace the SRS unit
(see page 24-951 .
I
Open or increased resistance in the SRS main harness;
replace the SRS main harness.
RIGHT SIDE WIRE
HARNESS
2P CONNECTOR
~~~"':/
SRS SIMULATOR
LEADC
07T AZ - SZSOllA
ond SRS INFlATOR
12
Il JACK)
07SAZ - TB4011A
SIMULATOR \
to
SRS UNIT
SRS MAIN HARNESS
18P CONNECTOR
10 11 12 13 \. 15 16 17 18
Wire side of female
terminals.
C806
24-75