Table of Contents
Advertisement
Interlock System
Park Pin Switch Replacement - '97 - 98 Models
SRS
components are
located in this area. Review the SRS
component
locations,
precautions,
and procedures in the SRS
section
(24)
before
performing
repairs
or service.
1, Remove the instrument panel lower
cover (see section 20).
2.
Remove the upper and lower steering
column covers (see section
17).
3. Remove the flange nuts and bolts
securing
the
steering column,
then
lower
the steering
column.
4.
Disconnect
the shift
lock solenoid and the park pin
switch connectors.
5. Remove the harness clamp bracket.
6. Remove the bolts
securing
the shift
lever
assembly,
then
remove the shift lever assembly.
7.
Remove
the screws securing
the shift lock
solenoid, then remove
the shift lock solenoid.
S.
Remove the park pin switch connector
from the shift lever
control bracket.
9. Remove the
control checker from
the
shift
lever
control bracket.
10.
Remove the park pin switch
from
the
control
checker.
SHIFT LEVER CONTROL
BRACKET
SCREW
2.5 N·m (0.25
kg/·m,
1.8 Ibf.ftJ
~t:f~~~/
PARK PIN
SWITCH CONNECTOR
SCREW
2.5 N'm
(0.25
kg/·m,
1.8lbf.ftJ
\
HARNESS CLAMP
BRACKET
9.3 N'm (0.95
kgf·m,
6.9 Ibf.ftJ
CONTROL CHECKER
11. Install the new park pin switch on the
control
checker.
12.
Install
the control checker on the shift lever
control
bracket.
\ . - - - - 7 PARK PIN SWITCH
13.
Route the park pin switch harness through the
cut out
of
the shift
lever control bracket, then install the park pin switch
connector
on
the
bracket.
14. Install the
shift
lock solenoid by
aligning
the joint
of
the
shift
lock solenoid plunger with the
tip of the shift
lock exten-
sion.
15.
Secure the
shift
lock
solenoid
with the
screws.
16.
Install the shift lever assembly in the reverse order of the removal.
'7.
Check
the operation of the shift Jever
and
the
shift
Jock.
14-150
Advertisement
Table of Contents
Troubleshooting
