Park Pin Switch Test - Honda CR-V 1997 Service Manual

Park Pin Switch Test
SRS components are located in this area. Review the SRS
component locations, precautions, and procedures in the
SRS section (24) before performing repairs or service.
1. Remove the instrument panel lower cover (see sec-
tion 20).
2. Remove the upper and lower steering column cov-
ers (see section
17).
3. Disconnect the park pin switch connector.
4. Shift the shift lever into
I:e:l
position, then check for
continuity between these connector terminals:
• '97 - 98 models: No.1 and No. 3 terminals of the
park pin switch connector.
• '99 - 00 models: NO.3 and No. 4 terminals of the
park pin switch/Over-Drive (010) switch connec-
tor.
There should be continuity.
'97 - 98 MODELS:
Terminal side of
male terminals
PARK PIN
SWITCH CONNECTOR
'99 - 00 MODELS:
Terminal side of
male terminals
5. Shift the shift lever out of the
~
position, and check
for continuity between the terminals as in step 4.
There should be no continuity.
6. If the park pin switch is faulty, replace it.
14-149