Honda CR-V 1997 Service Manual page 1392

Cable Reel
Replacement (cont'd)
16. Tighten the steering wheel bolt to the specified
torque, and connect the horn connector to the steer-
ing wheel. Then install the driver's airbag.
TORX BOLTS
9.8 Nom (1 .0 kgt'm , 7.2 IbUtl
Replace .
Use a T orx T30 bh:.
STfERING WHEEL BOlT
38 N·m 13.9 kgt·m, 28 IbUtl
Repl ace.
DRIVER'S AIRBAG
2P CONNECTOR
HORN CONNECTOR
17. Attach the cable reel 2P connector to the connector
holder. Then install (the knee bolster and) the driver's
dashboard lower cover.
24-94
CABLE REEL
2P
DRIVER'S DASHBOARD LOWER COVER
18. Reconnect the driver's airbag 2P connector to the
cable reel 2P connector, and re install the access
panel on the steering wheel.
19. Reconnect the battery positive cable. then the nega·
tive cable.
20. After installing the cable reel , confirm proper sys-
tem operation:
• Turn the ignition switch ON (III; the SRS indica-
tor light should come on for about six seconds
and then go off.
• Make sure both horn buttons work.
• Go for a test drive, and make sure the cruise con·
trol switches work.