Transmission - Honda CR-V 1997 Service Manual

Transmission
Removal
sure lifts, jacks, and safety stands are placed
properly. and hoist brackets are attached to the cor-
rect position on the engine Isee section 1).
• Apply tha parking brake and block tha raar wheels,
so vehicle will not roll off the stands and 'all on you
while working under
it.
NOTE: Use fender covers to avoid damaging painted
surfaces.
,. Disconnect the negative terminal, then disconnect
the positive terminal from the battery.
2. Remove the intake air duct and the air cleaner hous-
ing assembly.
3. Remove the starter cables. Remove the harness
clamp from the clamp bracket.
STARTER
CABLES
4. Remove the transmission ground cable terminal
and the radiator hose clamp from the transmission
hanger.
5. Disconnect the lock-up control solenoid valve con-
nector, then remove the harness clamp from the
clamp bracket.
RADIATOR HOSE
CLAMP
i n '
A
·
<i;c}!
~ . /
,
TRANSMISSION GROUND
CABLE TERMINAL
HARNESS CLAMP
%
~/:.-
'.
. LOCK·UP CONTROL
SOLENOID VALVE
CONNECTOR
6. Disconnect the vehicle speed sensor (VSS), the coun-
tershaft speed sensor, and the AfT gear position
switch connectors.
AIT GEAR POSITION
SWITCH CONNECTOR
\
COUNTERSHAFT
SPEED SENSOR
CONNECTOR
CONNECTOR
BRACKET
7. Remove the transmission housing mounting bolts.
TRANSMISSION HOUSING
MOUNTING BOLTS
(cont'd)
14-169