Honda CR-V 1997 Service Manual page 1342

Troubleshooting
The SRS Indicator Light Doesn't Go Off - '98 - 00 models (cont'd)
From page 24-43
( 8 )
I
Check the SRS indicator circuit:
1. Turn the ignition switch OFF.
2.
Remove the gaug e assembly . 0 0 not disconnect the
dashboard wire harness 5P co nnector from the gauge
assembly.
3. Turn the ignition switch ON (II).
4. Connect the dashboard wire harness 5P con necto r termi-
nals No.1 and No. 5 with a jumper wire .
Does the SRS indicator light go off?
YES
NO
Fluky SRS indic::.tor light circuit In the gauge assembly;
replace the SRS printed circuit board in the gauge
.... mbly.
Check for an open in the SAS indicator light circuit:
1. Turn the ignition switch OFF.
2.
Disconn ect the dashboard wire harness 5P connector
from the gauge assembly.
3. Check resistance between the No.6 terminal of the SRS
main harness l8P connector and the No.1 terminal of
the dashboard wire harness 5P connector; there should
be 0 - 1.0
o.
Is the resistance as specified?
VES
NO
(D)
To
page 24-46
(E)
To page 24-46
24-44
DASHBOARD WIRE HARNESS
5P CONNECTOR
DASHBOARD WIRE HARNESS
5P CONNECTOR
~ '
,CS09
BLU VEL
Wire side of female
JUMPER WIRE terminals
SRS MAIN HARNESS
'8P CONNECTOR
Wire side of female terminals
r-r7i'-f...".--"
C509
BLU
DASHBOARD WmE HARNESS
5P CONNECTOR