Rear Window Washer Tube Replacement - Honda CR-V 1997 Service Manual

Rear Window Washer Tube Replacement
NOTE:
• Take care not to scratch the related parts and body.
• When removing the clips, use a clip remover.
Remove the following parts from the left side of the vehicle, then pull the carpet back as necessary (see page 20-45).
• Front wheelwell protector (see page 20-89)
• Inner fender Isee page 20-891
• Kick panel Isee page 20-411
• Center pillar lower trim panel (see page 20-41)
• Front side trim Isee page 20-411
• Rear seat Isee page 20-631
• Cargo area floor and cargo storage bin (see page 20-
431
1>: Clip. harness cushion locations
A [> ,1 B [> ,1 C [> ,3
0 [> , 12
Route the washer tubes
to the washer reservoir
as shown .
WASHER
RESERVOIR
REAR WINDOW
WASHER MOTOR
• Rear trim panel and rear side trim panel (see page 20-
421
• Rear side trim (see page 20-41)
• Rear hatch glass support strut (body side, see page
20-781
• Quarter pillar trim panellsee page 20-421
• Cargo area light (see section 23)
• Headliner Irear edge, see page 20-441
o
REAR WINDOW
WASHER TUBE
GROMMET
WIRE
HARNESS
REAR WINDOW
WASHER TUBE
under the wire harness.
Route the washer tubes
under the wire harness.
Icont'dl
20-101